Avery Dennison Monarch 9906 MonarchNet2 - Manual (Page 33)

Using a Web Browser 3-7
Changing TCP/IP Settings
Only configure the settings required for your network/printer.
1. On the Protocols tab, set the Boot Method: Auto, BOOTP, DHCP, RARP, or Static.
2. Set the number of Boot Tries: 1-10. The default is 3. If you are having a problem
receiving an IP address with BOOTP, set this number to 10.
3. Change the IP Address if necessary.
4. Set or change the Subnet Mask.
5. Set or change the Gateway.
6. Select either No Subnet or No Gateway for RARP.
7. Select Automatic DNS Settings to automatically configure the domain name settings.
8. Enter the Domain Name.
9. Enter the Primary DNS Server’s IP address.
10. Enter the Secondary DNS Server’s IP address.
11. Select Enable Network Time to enable the network time protocol, which allows the
printer to query a time server on the network and synchronize the clock in the printer.
12. Enter the Time Server’s IP address. The printer waits 20 seconds for the server to
respond. The status is displayed within parentheses: “Waiting for Server,” “Time
Server Error,” or the current date and time.