Avery Dennison 6030 Operator Handbook - Manual (Page 81)

4. Press e . You will see:
Dot #### GOOD
Dot Value = ###
Valid values are 258-330. If the value is not within range,
please make a note and call Service.
To run the Temperature test:
1. From the PRINTHEAD TESTS menu, press > until you
see:
Dot resistance
Temperature
2. Press e . You will see:
Printhead
Temp = ###
Refer to the chart on the previous page.
3. Press b .
Checking the Battery
The Battery test displays the acceptable recharging capacity
of the battery cell.
To run the Battery test:
1. From the HDW TEST MENU, press > until you see:
Printhead
Battery
Chapter 10. Using Diagnostics
10-15