Avery Dennison 6030 Operator Handbook - Manual (Page 11)

Chapter 2. Getting Started
Before using the printer, you must
✔ charge the battery handle. (See "Charging the Battery
Handle" later in this chapter.)
✔ attach a fully charged battery handle. (See "Removing
and Attaching the Battery Handle" later in this chapter.)
✔ load your supplies. (See Chapter 3, "Loading
Supplies.")
✔ download your application, if necessary.
(See Chapter 5, "Transferring Data.")
n
See your System Administrator for information about the
application.
Using the Battery Handle ––––––––––––––––––––––––––––––––––––
The printer is powered by a 12VDC NiCd battery in the handle.
You can use and recharge the battery handle daily for
approximately two years.
n
See the label on the bottom of the handle about battery
recycling and disposal.
When the battery handle is not in use and not recharging, it
loses 2 to 3% of its charge per day. Extremely hot or cold
environments will increase or decrease the discharge rate.
Keep the battery handle charging when it is not in use. This
way, the printer is ready when you need it.
2-1