Avery Dennison 6030 Operator Handbook - Manual (Page 73)

To run the Print Speed test:
1. Press e to select Printing from the HDW TEST
MENU.
2. From the PRINTING MENU, press > until you see:
Test Pattern
Print Speed
3. Press e . You will see READY.
4. Press the trigger to print the test sample. Use the metric
scale below or a metric ruler to measure your test sample.
If your test sample measures more than 101 mm or less
than 99 mm, save your test sample and call Service.
n
This test must be performed in Non-peel mode.
To run the Gray Scale:
1. Press e to select Printing from the HDW TEST
MENU.
2. From the PRINTING MENU, press > until you see:
Print Speed
Gray Scale
3. Press e . You will see READY.
Chapter 10. Using Diagnostics
10-7