Avery Dennison 6030 Operator Handbook - Manual (Page 76)

Checking the Serial Port
This test is typically performed by Service or your MIS
department. To check the serial port, you perform a
"loop-back" test, which checks the port for receiving and
sending data from a host.
n
Contact your Service representative for the loop-back plug and
procedures.
To run the Serial Port test:
1. Connect the loop-back plug to the printer.
2. From the HDW TEST MENU, press > until you see:
Printing
Serial Port
3. Press e . You will see SENDING, and then
✦ if the test is successful, you will automatically return to
the HDW TEST MENU.
✦ if the test is unsuccessful, you will see:
No Data Received
PRESS A KEY
4. Press b .
If the printer fails to send or receive data, please make a note
and call Service.
6030 Operator’s Handbook
10-10