AMETEK SL Series Calibration Manual - Manual (Page 39)

Elgar Electronics Corporation Calibration
9. Input Voltage to the VSENSE terminal per Table 2-34 for the model
being calibrated.
10.
PRES ON, setting Power as table 36 for the model being calibrated.
11. PRES OFF.
12.
LOAD ON, Adjust using the
† keys until the load DAM matches
Current Setting value.
13. LOAD OFF.
14.
Repeat steps 1 through 13 (press
ª to return to Item 21) until no
further adjustments are necessary for the load DAM to match the
DMM reading.
MODEL Power Setting VSENSE input Current Setting
SLM-60-30-150 150.0W 50.00V 3.000A
SLM-60-60-300 300.0W 50.00V 6.000A
SLM-250-10-300 300.0W 200V 1.500A
SLM-500-10-300 300.0W 300V 1.000A
SLM-60-15-75 75.0W
50.00V 1.5000A
SLH-60-120-600 600.0W 50.00V 12.00A
SLH-60-120-1200 1200.0W 50.00V 24.00A
SLH-60-120-1800 1800.0W 50.00V 36.00A
SLH-60-240-1200 1200.0W 50.00V 24.00A
SLH-60-240-1800 1800.0W 50.00V 36.00A
SLH-60-360-1800 1800.0W 50.00V 36.00A
SLH-500-60-1800 1800.0W 300.00V 6.000A
Table 2-34. CP Mode, Level Low, Gain Adjustment Settings (Item 34)
SLM/SLH Calibration Manual 2-31