Doremi ShowVault / IMB - Manual (Page 63)

____________________________________________________________________________________
SHV.OM.001293.DRM Page 63 of 146 Version 1.5
Doremi Labs
7 Time/Date Set Up
Units are by default set to Pacific Time Zone (PST or PDT). This section provides information on
how to check and/or change the time and date.
7.1 Checking the Time/Date
There are two ways to check the current time/date: through the terminal and the GUI.
To confirm, through the GUI, that the time/date
of the unit is set correctly, go to Menu → Control
Panel → Time Setting and open the Date/Time tab ( Figure 68 ). Admin privileges are required
to access the application.
Figure 68: Date/Time Tab
To confirm, through the Terminal, that the time/date of the unit is set correctly, open a terminal
window by going to the Menu → System → Terminal menu.

Type: date and then press Enter.

The current date, time, and time zone will be displayed ( Figure 69 ).
Figure 69 : Terminal Window with Date Displayed
Current Date
and Time