Doremi ShowVault / IMB - Manual (Page 125)

____________________________________________________________________________________
SHV.OM.001293.DRM Page 125 of 146 Version 1.5
Doremi Labs
Figure 105: ShowVault Server
 Connect an Ethernet cable to the ETH0 port on the Doremi server and connect the other
end to a Gigabit (1000) Switch. Connect an Ethernet cable to the Command port on the
Dolby CP850 and connect the other end of the Ethernet cable to the same switch you
connected the Doremi server to (Figure 105 and Figure 107).
Important: The Dolby CP850 should be configured under the management/auditorium network
and NOT on the media network.
Note: The ShowVault server will need to be able to communicate with the Dolby CP850 (Same
sub-network/IP range).
Refer to Figure 106 for an example of how the equipment should be connected.
Eth0 Port
Eth1 Port
PCI-e Port