Doremi ShowVault / IMB - Manual (Page 30)

____________________________________________________________________________________
SHV.OM.001293.DRM Page 30 of 146 Version 1.5
Doremi Labs

Choose the correct projector model to connect to the unit using the Projector model
field(s).

Select the model series for the projector from the drop-down menu on the right. The
projector model series varies for all projector manufacturers.

Enter the Head IP address, and then click the test button.

If the DLP Head Connection Test fails, the IP address is invalid.

Choose to either enable or disable the subtitles.
Note: If the user enables subtitles without the unit being connected to a projector, then the
server will not operate properly.

Check the Enabled check box at the top right corner of the GUI.

Click the Save button to record the settings. A password confirmation page will appear.
Enter the password to save and record the settings.
5.1.2 Removing a Projector

To remove a projector click on its name on the left part of the Device Manager GUI.

Click the Delete button (Figure 22).
5.2 Automation Libraries Management
Support for theater automation control is also provided. The list of currently supported devices is
the following:

eCNA

JNior

A pre-built library of supported automation commands is available for each of these two
devices. These automation commands can then be added to Macro Cues as presented
in Section 6.2.
5.2.1 eCNA Device
5.2.1.1 eCNA Device Addition

To add the eCNA device, click the Add button in the Device Manager window.

The Add Device window will appear. Select eCNA and click the Add button.

The Device Manager GUI will be updated to reflect the addition of the eCNA device.

Input the eCNA Server IP address in the appropriate field (Figure 23):