Doremi ShowVault / IMB - Manual (Page 26)

____________________________________________________________________________________
SHV.OM.001293.DRM Page 26 of 146 Version 1.5
Doremi Labs

Select Yes to set eth0 and then press Enter.

Select No for Removable Device and then press Enter.

Select No for Automatically Configure Device with DHCP and then press Enter.

Enter the desired IP address for eth0 and then press Enter.

Enter the desired default gateway or leave empty and then press Enter.

Enter the desired subnet mask and then press Enter.

Select Yes to configure eth1 and then press Enter.

Select No for Removable Device and then press Enter.

Select No for Automatically Configure Device with DHCP and then press Enter.

Enter the IP address of eth1 and select OK – in the example, enter 192.168.100.50 and
then press Enter.
o Note: Do not put leading zeroes (0) in front of any numbers. For example, do not
input 192.168.100.050.

Enter the desired default gateway or leave empty and then press Enter.

Enter the desired subnet mask and select OK – in our example, enter the same subnet
mask as the projector: 255.255.255.0 and then press Enter.

Enter the IP Address of the System's Domain Name Server (or leave empty) and then
press Enter to exit the wizard.
To verify the setup, go to Menu → Doremi Apps. → Diagnostic Tool and verify the IP Address
under the Diagnostic Tool System Tab.
Note: The configuration for Ethernet 2 that might be asked by the Ethernet configuration wizard
is not needed at this point. It is ok to skip this step if asked for the configuration.