CIRCUTOR PowerStudio Series - Manual (Page 62)

PowerStudio
62 User Manual
 Force variables: This allows device variable values to be forced. Only
devices where it is possible to force one or more variables can be shown,
for example digital outputs.
 Filter: This will show the filters added to the application. See section 7.6
 Screens: Will show the various SCADA screens available to configure the
application. See section 6.
 View: Enables the chosen screen to be viewed.
 Force variables: Permits variables to be forced using the "force variable"
controls on the SCADA screens.
 Reports: Shows the defined reports. See section 5.
 Events: Will display the various events resources (see section 7.9 Events) that
can be added to a profile:
 Run event actions in client application. Will enable programmed actions to
be carried out on the client application when enabled, acknowledged,
disabled or while events are being produced.
 Acknowledge reported events. Allows a reported event to be
acknowledged.
 Active events display. Enables or disable active events display.
 Reported events display. Enables or disables display of reported events.
 Display events variables: Allows graphs and tables of the variables
generated by events to be displayed (see section 7.9.3 Event Variables)
 Display event browser. Displays the list of events stored on file, whether
reported or not.
 Remote events: Displays the different event resources from remote engines to
which the engine application may be connected (See section 7.9 Events). These
events may be added to a profile:
 Display active events. Enables or disables active events display.
 Display reported events. Enables or disables display of reported events.
 Acknowledge reported events. Allows a reported event to be
acknowledged.
 Calculated Variables Allows graphs and tables of calculated variables configured
on the software to be displayed (see section 7.5 Calculated variables)
 View: Allows the calculated variables to be displayed or not displayed.
 Force variables: Allows the value of the variables to be forced or not
forced.
 Others Displays the system events table.