CIRCUTOR PowerStudio Series - Manual (Page 18)

PowerStudio
18 User Manual
Depending on the device being configured, some of these parameters may not appear.
• Delay: Value in milliseconds. This value known as “Timeout” is used to control the time
that software will await the response from a device. The value entered will be added to the
default waiting time for a response from the device.
• Speed of Communication: Allows communication speed between the software and the
device to be selected. This speed is automatically assigned by default, but it may also be
forced to the desired speed. "Automatic" means the software configure the devices using
the maximum speed common to them all. If specific speed is selected, the software will
configure the devices at this speed, and devices unable to communicate at that speed no
longer communicate.
Speeds are configured to accept changes in the device screen (see 3.1.1 Adding a First-
level Device)
Once speeds are configured, if there have been any problems the following dialogue will
appear.
Devices not configured due to unmatched speeds are shown here. There are two types of
warnings
when there have been errors in communication with the device. Once the problems have been
resolved speed configuration can be attempted once more by clicking the ‘Re-try ’ button.