CIRCUTOR PowerStudio Series - Manual (Page 38)

PowerStudio
38 User Manual
5.2.1.8 Analogue bar control
Use this tool to include an analogue bar in a report. This control, like others, can be placed
anywhere in the report and enables a large number of different variables to be viewed.Select this tool
and draw a selection box on the report by keeping the left mouse button pressed. The following
properties may be configured from this control:
Selection of values to be viewed in the control, maximums,
minimums or both.
We can choose between normal variable or power
factor/cosine phi.
Indicates the orientation of the control between horizontal or
vertical.
Indicates where to display the control value label: above, below,
left or right.
Select the variable that the control will monitor.
We select the decimals that the control will show.
Indicate the maximum value the control can display.
Indicate the minimum value the control can display.
Indicate the maximum prealarm value the control can display.
Indicate the maximum alarm value the control can display.
Indicate the minimum prealarm value the control can display.
Indicate the minimum alarm value the control can display.
Indicate whether or not messages relating to alarm and pre-alarm values
are displayed in the control.
5.2.1.9 Primitive control
The primitive control will allow us to draw lines, rectangles and ellipses of different sizes,
orientation and colour. The properties that can be configured from this control are: