1activating the service mode, 1 activating the service mode – Pilz PSSnet SHL 8T MRP User Manual
Page 136
Diagnosis
136
7.11 Service mode
PSSnet SHL - Web- based Interface
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
7.11.1 Activating the service mode
Prerequisites:
– HIPER-Ring ports are defined (HIPER-Ring or MRP-Ring).
– The supply voltage is redundant at P1 and P2.
Note: If there is no redundant voltage when the service mode is being acti-
vated (by clicking on “Set” - see below), the Switch immediately creates the
two transmission areas. Depending on the settings already entered, this can
break your link to the Switch.
Select the Diagnostics:Service Mode dialog.
Activate “Mode”.
Enter a number not equal to 0 or 1 in the “VLAN” field. Enter a VLAN ID
for a new VLAN in order to keep the settings for existing VLANs.
Click on “Set”. The device outputs the following warning:
It you are sure that your link to the Switch will not be broken, click on “OK”
to activate the service mode.
The device will indicate in all dialogs that the service mode is activated.