Pilz PSSnet SHL 8T MRP - Manual (Page 128)

Diagnosis
128
7.6 Signal contact
PSSnet SHL - Web- based Interface
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
7.6.3 Device status
Select the tab page “Alarm 1” or “Alarm 2” (for devices with two signal
contacts).
In the “Mode Signal Contact” field, you select the “Device status” mode.
In this mode, the signal contact is used to monitor the status of the device
(see on page 142 „Device Status“) and thereby makes remote diagnosis
possible.
The device status “Error”
(see on page 142 „Device Status“) is reported
by means of a break in the contact via the potential-free signal contact
(relay contact, closed circuit).
7.6.4 Configuring traps
Select generate Trap, if the device is to create a trap as soon as the
position of a signal contact changes when function monitoring is active.
Figure 46: Signal contact dialog