Pilz PSSnet SHL 8T MRP - Manual (Page 125)

Diagnosis
PSSnet SHL - Web- based Interface
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
7.5 Device Status
125
The events which can be selected are:
Select "Generate Trap" in the "Trap configuration" field to activate the
sending of a trap if the device state changes.
Note: With non-redundant voltage supply, the device reports the absence of
a supply voltage. You can prevent this message by feeding the supply volt-
age over both inputs, or by switching off the monitoring
(see on page 144
„Signal contact“) .
Name Meaning
Power supply ... Monitor/ignore supply voltage(s).
Temperature Monitor/ignore temperature thresholds set (see on page 16 „System“) for
temperatures that are too high/too low
Module removal Monitor/ignore the removal of a module (for modular devices).
SCA removal Monitor/ignore the removal of the SCA.
Connection error Monitor/ignore the defective link status of at least one port.
The reporting of the link status can be masked for each port by the
management
(see on page 26 „Port configuration“) . Link status is not
monitored in the state on delivery.
HIPER-Ring Monitor/ignore the discard of the existing redundancy (in Ring Manager
mode).
State on delivery: ring redundancy is not monitored.
Ring/Network Cou-
pling Monitor/ignore the failure of the redundancy.
State on delivery: ring redundancy is not monitored.
The following conditions are also reported by the device in standby
mode:
– Defective link status of the control line
– Partner device is in standby mode.
Fan Monitor/ignore fan function (for devices with fan).
Table 44: Device Status