HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 5)

5
WarnInGs and safeTY noTes
A
The allowable DC input voltage is 11-18V DC.
A
Keep the charger away from dust, damp, rain, heat, direct
sunlight and excessive vibration.
A
If the charger is dropped or suffers any type of impact, it
should be inspected by an authorized service station before
using it again.
A
This charger and the battery should be put on a heat-resis-
tant, non-flammable and non-conductive surface.
A
Never place a charger on a car seat, carpet or similar surface.
Keep all flammable, volatile materials away from the operat-
ing area.
A
Verify the specifications of the battery to be charged or dis-
charged to ensure it meets the requirements of this charger.
If the program is set up incorrectly, the battery and charger
can be damaged.
A
Fire or explosion can occur due to overcharging.
A
To avoid a short circuit between the charge lead, always con-
nect the charge cable to the charger before connecting the
battery. Reverse the sequence when disconnecting.
A
Never attempt to charge or discharge the following types of
batteries:
•
A battery fitted with an integral charge circuit or a
protection circuit