HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 43)

43
Toggle up (▲) until you see the “
SAfETY
TIMER
” screen. Toggle right (►) once and
“
ON
“ or “
Off
” will begin flashing. Toggle up (▲) or down (▼) once to
change this setting. Toggle right (►) once and the timer value will
begin flashing. Toggle up (▲) or down (▼) to adjust the timer value.
Toggle right (►) once to set the Safety Timer.
capacity cut-off
This program provides a maximum capacity protection function.
If the delta-peak voltage cannot be detected or the Safety Timer
times out, the charge process will stop automatically when the
user-set maximum charge capacity is reached in order to prevent
accidental overcharging.
Toggle up (▲) once and you will see the
“
CAPACITY CUT-Off
” screen. Toggle right
(►) once and “
ON
“ or “
Off
” will begin flashing. Toggle up (▲) or
down (▼) once to change this setting. Toggle right (►) once and
the amperage value will begin flashing. Toggle up (▲) or down (▼)
to adjust the amperage value. Toggle right (►) once to set the the
Capacity Cut-Off.
key beep & buzzer
A beep sounds to confirm the user’s operation every time a button
is pressed. The buzzer or melody sounds at various times during an
operation to confirm a different mode change.
Toggle up (▲) once and you will see the “
KEY
BEEP BUzzER
”screen. Toggle right (►) once
and (Key Beep) “
ON
” or “
Off
” will begin flashing. Toggle up (▲) or
down (▼) once to change this setting. Toggle right (►) once and
(Buzzer) “
ON
” or “
Off
” will begin flashing. Toggle up (▲) or down
(▼) once to change this setting. Toggle right (►) once to set the
Key Beep and Buzzer settings.
SAfETY TIMER
ON 120Min
Capacity Cut-Off
ON 5000mAh
Key Beep ON
Buzzer ON
sYsTeM seT uP (cont.)