HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 30)

30
nicd/niMH - cHarGe Mode (cont.)
nicd/niMH - auTo cHarGe Mode
Toggle and hold the joysick to the right (►) for three seconds to
begin charging.
Once charging has commenced, the charger
will display the following real-time informa-
tion: battery type, charging current, battery voltage, charging time
and charged capactiy.
Once the battery is fully charged, the screen will read
“
END:fINIShED
” and the charger will emit a chiming sound.
Toggle left (◄) once to stop charging. You may toggle left (◄) at
any time during the charging process to stop charging.
In this program, the charger detects the condition of the battery
connected to the output and automatically charges the battery. In
this mode, you should set up the upper limit of the charge current
to avoid damage by feeding excessive current. Some batteries of
low resistance and capacity can lead to higher current in the Auto
Charge mode.
NiMh 1.6A 5.96V
ChG 003:43 00090
before You beGIn cHarGInG Your baTTerY,
Make sure You HaVe read and undersTand
all of THe WarnInGs and safeTY InforMaTIon
conTaIned on PaGes 4-9.
Select the correct battery type by following the instructions on
page 29. Once you have set the correct battery type, toggle up (▲)
or down (▼) until you see the “
NiMh Auto ChARGE
” screen.
Toggle right (►) once and the amp rate value
will begin flashing. Toggle up (▲) or down
( ▼) to adjust the value to the desired rate. Follow the instructions
provided with your battery when setting the amp rate.
NiMh Auto ChARGE
CURRENT 5.0A
Warning