HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 35)

35
This program is only suitable for charging Pb (lead-acid) batter-
ies with nominal voltages of 2 to 20V. A Pb (lead-acid) battery is
significantly different from NiCd/NiMH batteries. Pb batteries can
only deliver lower currents than in comparison to their capacity.
The same restriction applies to the charging process. Consequently,
the optimum charge current can only be 1/10 of the capacity. A Pb
battery cannot be used for fast charging. Please follow the instruc-
tions provided by the battery manufacturer.
The X1 Pro offers the following NiCd/NiMH charge modes: Charge
and Discharge.
before selecTInG a cHarGe Mode, IT Is crITI-
cal THaT You selecT THe correcT TYPe of
baTTerY To be cHarGed. faIlure To do so can
resulT In daMaGe To THe baTTerY.
selecting the battery Type
When you power on the X1 Pro, you will automatically be taken
to the “
LiPo BALANCE
” screen. Toggle left (◄) once to enter the
“
PROGRAM SELECT
” screen. Toggle up (▲) or down (▼) until you
see the battery type you wish to charge. Now, toggle right (►)
once to enter the “
Pb
” program The default
charge mode will be “
ChARGE
”.
Pb (lead-acId)
Pb cHarGe Modes
PROGRAM SELECT
Pb
before You beGIn cHarGInG Your baTTerY,
Make sure You HaVe read and undersTand
all of THe WarnInGs and safeTY InforMaTIon
conTaIned on PaGes 4-9.
Pb cHarGe Mode
Warning
Warning