HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 27)

27
lITHIuM - dIscHarGe Mode (cont.)
cHarGe ProGraM as THIs Is THe safesT MeTHod
of sTorInG Your lITHIuM cHeMIsTrY
baTTerIes.
In dIscHarGe Mode, lITHIuM baTTerIes can
be dIscHarGed WITH or WITHouT THe use of a
balance adaPTor. THe use of a balance adaP-
Tor Is recoMMended for dIscHarGInG anY
baTTerY THaT Has a balance lead.
note
See page 16 for the appropriate charging connections setup for
this operation.
First, select the correct battery type by fol-
lowing the instructions on page 18. Once you
have set the correct battery type, toggle up (▲) or down (▼) until
you see the “
LiPo DISChARGE
” screen.
Toggle right (►) once and the amp rate val-
ue will begin flashing. Toggle up (▲) or down
( ▼) to adjust the value to the desired rate. Follow the instructions
provided with your battery when setting the amp rate.
Toggle right (►) again and the cell count
value will begin flashing. Toggle up (▲) or
down (▼) to adjust the cell count. This will automatically change
the voltage value to the correct setting for the selected cell count.
The cell count should match the battery label exactly.
LiPo DISChARGE
8.1A 22.2V(6S)
LiPo DISChARGE
0.8A 22.2V(6S)
LiPo DISChARGE
0.8A
11.1V(3S)
before You beGIn dIscHarGInG Your baTTerY,
Make sure You HaVe read and undersTand
all of THe WarnInGs and safeTY InforMaTIon
conTaIned on PaGes 4-9.
Warning