HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 31)

31
Toggle and hold the joysick to the right (►) for three seconds to
begin charging.
Once charging has commenced, the charger
will display the following real-time informa-
tion: battery type, charging current, battery voltage, charging time
and charged capactiy.
Once the battery is fully charged, the screen will read
“
END:fINIShED
” and the charger will emit a chiming sound.
Toggle left (◄) once to stop charging. You may toggle left (◄) at
any time during the charging process to stop charging.
before You beGIn dIscHarGInG Your baTTerY,
Make sure You HaVe read and undersTand
all of THe WarnInGs and safeTY InforMaTIon
conTaIned on PaGes 4-9.
Select the correct battery type by following the instructions on
page 29. Once you have set the correct battery type, toggle up (▲)
or down (▼) until you see the “
NiMh DISChARGE
” screen.
Toggle right (►) once and the amp rate value
will begin flashing. Toggle up (▲) or down
( ▼) to adjust the value to the desired rate. Follow the instructions
provided with your battery when setting the amp rate.
Toggle right (►) once again and the final voltage value will begin
flashing. Toggle up (▲) or down (▼) to adjust the value to the
desired rate. The discharge current ranges from 0.1 to 8.0A and the
final voltage ranges from 0.1 to 25.2V.
NiMh 1.6A 5.96V
AUT 003:43 00090
NiMh DISChARGE
0.1A CUT: 1.0V
Warning
nicd/niMH - auTo cHarGe Mode (cont.)
nicd/niMH - dIscHarGe Mode