HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 44)

44
sYsTeM seT uP (cont.)
Input Power low cut-off
This function monitors the voltage of the input source used to
power the charger. If the voltage drops below the user setting, the
program will end immediately to protect the input source.
Toggle up (▲) once and you will see the
“
INPUT POWER LOW CUT-Off
” screen.
Toggle right (►) once and the voltage value will begin flashing.
Toggle up (▲) or down (▼) to adjust the voltage value. Toggle
right (►) once to set the Input Power Low Cut-Off.
external and Internal Temperature
Toggle up (▲) once and you will see the “
Ext.
Temp and Int. Temp.
” screen. This screen shows the
external temperature of the battery and the internal temperature of
the charger. The battery temperature reading requires a tempera-
ture sensor that is sold seperately.
load factory set
This screen shows the external temperature
of the battery and the internal temperature
of the charger. The battery temperature reading requires a tem-
perature sensor that is sold seperately.
Toggle and hold the joysick to the right (►) for three seconds to
load the factory settings.
Version
This screen shows the version number.
WarnInGs and error MessaGes
Input Power Low
Cut-off 10.0V
Ext. Temp 0C
Int. Temp 20C
LOAD fACTORY SET
ENTER
VERSION
1.00