FeiYu Tech FY-Panda2 Autopilot - Manual (Page 52)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 51
2 ) Connect PandaⅡ to our GCS software, using aerial photography route
planning function to set a Line Spacing 200m,Distance Buffer 200m, altitude 200m
route and upload the route. Set every 4 seconds to automatic take a photo. Cancel
the Route loop function .
3 ) According to the flight space set the landing point, planning out of the land
routes.
4 ) Open the camera and make sure the camera is ready.
5 ) Prepare for throwing take off. Click on . Wait the motor reaches
maximize speed, then push the aircraft into the air.
6 ) Wait the aircraft climb to 100m and circling around the Home point.
7 ) Through GCS to set , and wait the aircraft automatic
climb to 200m.
8 ) Click on to start automatic navigation flight.
9 ) Wait the aircraft to fly according to the route you have set, then click on
to start automatic take photo.
10 ) Wait the aircraft complete the flight mission and cancel the automatic take
photo function.
11 ) Click on ,and wait the aircraft automatic return to home.
13.5 Firmware Upgrade
Panda
Ⅱ contain the basic function of firmware upgrade, you can do the firmware
upgrade by yourself, just need to download the latest firmware from: www.feiyu-tech.com
Connection mode is as follows:
Firmware upgrade procedure:
1) Download the latest firmware and firmware upgrade software from our official
website.
2) Install and open the firmware upgrade software, choose the right COM number
and click on ―Open port‖.
3) Choose the firmware which you need to upgrade.