FeiYu Tech FY-Panda2 Autopilot - Manual (Page 50)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 49
Balance Mode. While flying in a straight line and having no input through the transmitter
sticks.
Please through the to record servo neutral.
(16) Target speed setting (Default setting is 60km/h).The flight speed is very
important, you can not optional Settings. The speed must can keep aircraft keep normal
flight. We suggest not increase the settings too high, it may cause very unusual flying
behavior and may result in damage of your aircraft due to excessive throttling. You can
through watch the ―GPS speed‖ shows on our GCS software and assess the flight
cruising speed to set the target speed.
Through —―Param1‖--- ,click on ―set‖. After that,
please do not forget to click on to save the setting to our Panda
Ⅱ
(17) Switch SW2 to Return To Launch (RTL)mode to watch the aircraft automated
return to home or not. Upon reaching the home point it will automatically engage auto
circling, while it waits for your further instructions.
(18) After Return To Launch test, please switch SW2 to ―Path Navigation mode‖ to
watch the aircraft according to preset route fly or not.
(19) Take off and finish the first flight test.
13. Introduction To Other Functions And Settings
13.1 Operation For The Click Point Flight
Switch to ―Preset Path & Waypoint Navigation Mode‖ or ―Auto Circling Mode‖.
Click on the button then you just need to click the flight target you want in
the map. The aircraft will fly to the target point and circling around it waiting for your next
instruction.
13.2 Route Loop Function
The default path navigation in Panda
Ⅱ is auto repeat .when the plane fly over the
last waypoint it will fly back to the first waypoint. You can cancel this default value via the
GCS software button, then the plane will not fly back, just circle in the last