User guide, 14 configuring the osd, 1 adjusting the display – Eagle Tree Vector User Manual
Page 54

USER GUIDE
54
5.14 Configuring the OSD
The Vector’s built-in color OSD has many advanced features and display options. Even so, it can be easily
configured to display basic information that is sufficient for most
pilots.
The Vector’s OSD will automatically continue to show information on
the screen (in grayscale) if your camera should stop functioning in
flight.
Note: EagleEyes telemetry is NOT available without a
functioning camera connected to the OSD.
Some Skyzone™ goggles are not compatible with the Vector’s
no-camera mode. We are investigating this issue. Make sure you test
your goggles with no-camera mode if you think you will need this
mode.
All OSD settings are made in the “OSD Setup” menu, from the main
menu.
The steps for configuring the OSD are:
Adjusting the display so that it is easily readable through your goggles or monitor
Setting your preferred display units
Deciding which items you want to display on the OSD
screen
Setting desired alarms and alerts
5.14.1
Adjusting the Display
If you are happy with the appearance of the display, no further
changes are needed.
If the OSD information is not centered on your screen, change the
horizontal and vertical screen shift settings to reposition it.
Multirotor is armed, but an error has been
detected. Check the OSD notification area to
determine the cause of the error.
Multirotor is armed.
A 2D Flight Mode is selected
A 3D flight mode (including ‘gyro mode’) is selected
A Loiter flight mode is selected
USB mode is active