Ditch Witch JT60AT - Manual (Page 154)

Systems and Equipment - 154
JT60/JT60 All Terrain Operator’s Manual
Cruise Control
Cruise Control
During the bore, you can set the desired thrust, pullback, and rotation speeds to match ground conditions.
Cruise control enables the unit to maintain these settings hands-free. You can engage, disengage,
override, and resume these settings at any time.
Engage
Adjust Settings
IMPORTANT: In order for cruise control to function, front wrench must be open and shuttles must be
under pipe box.
Thrust/Pullback and Outer Rotation Control Thrust/Pullback Control Only
1. Position joystick so that thrust or pullback and
outer rotation are at desired speeds.
2. Press SET. Green control cycle light will come
on.
3. Release joystick.
1. Position joystick to desired thrust or pullback
setting.
2. Press SET. Green control cycle light will come
on.
3. Release joystick.
4. Operator controls rotation with joystick.
Setting Instructions
Thrust or Pullback • To increase thrust or pullback speed while joystick is in neutral position,
press RESUME.
• To decrease thrust or pullback speed while joystick is in neutral position,
press SET.
Outer Rotation • To increase outer rotation speed, move joystick to left and press
RESUME.
• To decrease outer rotation speed, move joystick to left and press SET.
Outer Rotation Speed
Limit (AT Rock Mode) IMPORTANT: Outer pipe rotation speed is automatically limited when inner
rotation is on.
• To increase outer rotation speed limit, move joystick to left and press
RESUME.
• To decrease outer rotation speed limit, move joystick to left and press
SET.