ADLINK PCI-8154 - Manual (Page 105)

MotionCreatorPro 95
1. ALM Logic and Response mode: Select logic and
response modes of ALM signal. The related function call
is _8154_set_alm().
2. INP Logic and Enable/Disable selection: Select logic,
and Enable/ Disable the INP signal. The related function
call is _8154_set_inp()
3. ERC Logic, Active timing and ERC mode: Select the
Logic, Active timing and mode of the ERC signal. The
related function call is _8154_set_erc().
4. EL Response mode: Select the response mode of the
EL signal. The related function call is
_8154_set_limit_logic().
5. ORG Logic: Select the logic of the ORG signal. The
related function call is _8154_set_home_config().
6. EZ Logic: Select the logic of the EZ signal. The related
function call is _8154_set_home_config().
7. Buttons:
Z Next Card: Change operating card.
Z Next Axis: Change operating axis.
Z Save Config: Save current configuration to 8154.ini and
8154MC.ini.
8. I/O Status: The status of motion I/O. Light-On means
Active, while Light-Off indicates inactive. The related
function is _8154_get_io_status