Replace the lamp-replacement, Opening cover and fasten the screws, Q insert the new lamp unit fully – Ask Proxima D-ILATM Pro AV SX1 User Manual
Page 49: Inside and fasten the screws
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing the Lamp (Cent.)
2 Loosen the lamp-unit screws, raise
^ the handle, and pull out the lamp
unit.
Loosen the two screws with a flat-end screwdriver.
' The screws are fitted so that they do not come off the lamp-
unit.
Q Insert the new lamp unit fully
^
Inside and fasten the screws.
Fasten the two screws with a flat-end screwdriver.
C AU TIO N
> Do not touch the glass surface of the lamp directly with
your hand as well as staining it. If you touch with a bare
hand, stains on your hand may adhere to the lamp,
possibly
preventing
the
lamp
from
performing
as
specified due to a shortened lamp life, a darkened screen,
etc. To handle a new lamp, hold its plastic part. Never
touch the metal part or the front glass surface.
Replace the lamp-replacement
opening cover and fasten the
screws.
Fasten the two screws with a flat-end screwdriver.
Lamp-replacement
C AU TIO N S
' Install the lamp unit and close the lamp-replacement opening cover correctly; otherwise, a safety switch is activated
to prevent the projector from operating.
' If the claw on the lamp-replacement opening cover is damaged, the projector may not operate. Then, replace with a
new lamp-replacement opening cover.
' After replacing the lamp, be sure to reset the lamp use time (see page 50).
49