Ask Proxima D-ILATM Pro AV SX1 - Manual (Page 26)

Basic Operations
Projector’s buttons
stand by (!) O Z
“stand by” indicator
“operate” indicator
- “operate” button
lamp replace ( )
temperature CD
a , ®
Remote control unit
The following describes the basic procedure for normal use of
the projector.
1. Turning on the power
m Turn on the MAIN POWER
switch.
ON [ I ]:The main power turns on and the “stand by”
indicator comes on.
Projector’s indicator
Press the “operate” button on
the projector.
(Or press the remote control’s
OPERATE button for one second
or more.)
• The “operate” indicator comes on.
•About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Projector
Remote control unit
' After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
Turning off the Power
® Press the “operate” button on
the projector.
(Or press the remote control’s
OPERATE button for one second
or more.)
• The “stand by” indicator changes to blinking, and the
projector goes into cool-down mode.
Example of the projector’s button Projector
i (Blinking)
1
Stand by (I) •xjQ;" I
Turn off the MAIN POWER switch
after the “stand by” indicator
changes to steady on.
OFF [o]: The MAIN POWER switch turns off and the
“stand by” indicator goes off.
Projector
(Off)
stand by (!) O
26
Do not turn off the MAIN POWER switch during cool
down mode (the “stand by” indicator blinking). Turn it
off after the “stand by” indicator becomes on (stand-by
mode).