Ask Proxima D-ILATM Pro AV SX1 - Manual (Page 44)

Operating the Main Menu (Cent.)
Setting and Adjusting Other Functions (OPTIONS) (Cent.)
■Remote control unit
O P E R A T E C O M P U T E R V I D E O
CZZ)
^ Set (adjust) the desired item with the
^ cursor button ◄ or ►.
• To adjust multiple items, repeat steps 4 and 5.
MENU/ENTER
button
Cursor buttons
PAGE BACK button
■Submenu items
[OPTIONS menu]
y O P T I O N S
M E N U A U T O O F F N O
L I N E D I S P L A Y O N
R I G H T L E F T R E V . O F F
T O P B O T T O M I N V , O F F
C L A M P B P
R E S I Z E O N
B A C K C O L O R B L U E
C O L O R T E M P . M I D D L E
A S P E C T C H A N G E 4 : 3
S L E E P T I M E 3 0 M i n .
L A M P T I M E 1 0 H .
• The selected item is shown in magenta coior. items shown
in gray coior cannot be operated or set in the current mode.
• items to be set (adjusted) are different when AV signais are
input and when computer signais are input.
• When you turn the RESiZE function ON, aiiowing the screen
to be eniarged virtualiy to its fuli size for projection (resizing
dispiay), the video image (resolution) becomes coarse.
Adjustment item
MENU AUTO
OFF
LINE DISPLAY
RIGHT LEFT
REV.
TOP BOTTOM
INV.
CLAMP
RESIZE
Button
*/►
Adjustment content
Sets whether to clear the menu display
automatically a fixed time later or not.
(Factory setting : NO)
YES: Clears the display automatically in
about 25 seconds.
NO : Does not clear the display
automatically.
YES
Sets whether to show the line display (Y/C,
VIDEO, etc.) at the top of the projected
screen or not. (Factory setting : ON)
OFF; Does not show the line display.
ON : Shows the line display.
(The line display disappears about 5
seconds after it is shown.)
OFF ON
Reverses video image right-to-left.
(Factory setting : OFF)
OFF: For the front method
ON : For upside hanging from the ceiling
OFF
ON
Inverses video image upside-down.
(Factory setting : OFF)
OFF: For normal set-up
ON : For upside hanging from the ceiling
OFF .#»»»»»#. ON
Sets the clamp pulse’s position at the back
porch (BP) or on the sink tip (ST).
Normally, the clamp is used at BP. If, with
some PCs or workstations, the screen
becomes unstable such as being too dark
or too bright, try to switch to ST.
(factory setting: BP)
BP : The clamp pulse is positioned at the
back porch.
ST : The clamp pulse is positioned on the
sink tip.
ST
When the number of pixels (resolution)
sought by the input video is smaller than
that (resolution) of D-ILA device, the video
image is then enlarged to virtually full
screen size of D-ILA device and projected
(resizing display). (Factory setting : ON)
Cannot be set for AV input.
OFF : Does not enlarge the video image for
projection. When the number of
pixels sought by video image is
smaller than that of D-ILA device,
projection takes place on a small
screen size with a black area around
the screen.
ON : Enlarges virtually to the full screen
size of D-ILA device for projection
(resizing display).
OFF «#—«► ON
44