Ask Proxima D-ILATM Pro AV SX1 - Manual (Page 11)

Controls and Features (cont.)
Connector Panel
m “S-video” input terminal (Mini DIN 4 pin)
Connect this terminal to the S video output terminal of a
video deck, etc.
|T1 “video” input terminal (BNC)
Connect this terminal to the composite video output terminal
of a VCR, etc. Use the BNC-RCA conversion plug to
connect the RCA cable.
[^1 Component signal input terminals (BNC)
These are input terminals for component -“y,cb,cr(Y,CB,CR)
or y,b-y,r-y(Y,B-Y,R-Y)”- signals and Hi-Vision base band
-“Y, P b , P r ”- signals. Devices with component signal output
terminals for NTSC or HI- Vision can be connected.
in “audio L/R” input terminals (pin jacks)
Of devices connected to the video input terminals, such as
a VCR, etc., the audio output terminals of the device to be
projected is connected to these terminals. The input audio
signal is reproduced by the speakers of the projector. The
signal is also output from the “audio OUT” terminal of the
projector.
* When the input signal is stereo signal, connection should
be made to both L and R.
* Signals from a monaural device should be connected to only
L. That way, the projector’s speakers and the “audio OUT’
terminal produce the same sound from both L and R.
|5~| “audio OUT” terminal (stereo mini jack)
Of input signals inputted to the projector, the audio signal
of the device being projected is output. Volume should be
adjusted using the VOL. (- 1 -/-) buttons on the remote control
or VOLUME on the setting menu. When a cable is
connected to this jack, no audio sound is produced from
the projector’s speakers.
“remote” terminal (mini jack)
Connect an infrared remote control extension unit, etc. to
this jack.
* For details, consult your dealer.
\j] RS-232C terminal (D-sub 9 pin)
This is a RS-232C interface-specified terminal. This
projector can be controlled by a computer connected
externally.
* For details, consult your dealer.
“monitor” terminal (D-sub 3-row 15 pin)
The computer input signal projected on the screen is output.
A display unit can be used by connecting it to this terminal.
To select the proper audio input for video input:
The video input terminals (AV IN input terminals) can be switched
with the projector’s “video” button or remote control’s VIDEO button.
However, since this projector has only single audio input terminal,
reconnect audio input in accordance with the AV device to be used.
11