Aiwa LCX-301 - Manual (Page 30)

I
BASIC RECORDING
4
II -
Preparation
• Wind up the tape to the point where recording will start.
• Only normal (type I) tapes can be recorded.
1 Insert the tape to be recorded on into the deck.
Insert the tape with the side to be recorded first facing
out from the unit and the exposed side down.
2 Press the TAPE/REV MODE button to select the
reverse mode.
To record on one side only, turn on
To record on both sides, turn on or C2T5.
3 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the disc.
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the AUX/
VIDEO button and play.
4 Press the • REC button to start recording.
When the selected function is CD, playback and recording
start simultaneously.
When using the remote control, first press the • REC button
and then press the button within 2 seconds.
E3 will be displayed during recording.
To stop recording, press the ■ button.
To pause recording, press the II button. (Applicable when the
source is TUNER or AUXA/IDEO.) To resume recording, press
again.
To reduce the noise interference of an MW/LW broadcast
(for K model)
Press the BAND button while pressing the SHIFT button on the
remote control to reduce the noise interference when recording
an MW/LW broadcast. Each time the buttons are pressed, the
dot light © is turned on and off in the display window. -► 0
Recording cannot be done when the TAPE button is selected.
©
l.iW ►
C J ^ K i u
J J f
i \ / i 1 1
1 1 //'/
30