YSI MultiLab 4010-3 - Manual (Page 96)

Settings MultiLab 4010-3
96 ba76143e03 08/2013
10.6 Sensor-independent settings
10.6.1 System
To open the Storage & config menu, press the key in the measured
value display. After completing the settings, switch to the measured value dis-
play with .
Default settings are printed in bold.
Menu item Setting Explanation
System / General / Language Deutsch
English
(more) Selects the menu language
System / General / Audio signal on
off
Switches on/off the beep on key-
stroke
System / General / Brightness 0 ... 10 ... 22 Changes the display brightness
System / General / Tempera-
ture unit °C
°F Temperature unit,
degrees Celsius or degrees Fahren-
heit.
All temperature values are displayed
with the selected unit.
System / General / Stability
control on
off Switches on or off the automatic sta-
bility control during measurement
(see section 10.6.3 A
UTOMATIC S TA -
BILITY CONTROL , page 97 )
System / Interface / Baud rate 1200, 2400, 4800,
9600, 19200 Baud rate of the USB Device inter-
face
System / Interface / Output for-
mat ASCII
CSV Output format for data transmission
For details, see section 12 T
RANSMIT -
TING DATA
, page 108
System / Interface / Decimal
separator Dot (xx.x)
Comma (xx,x) Decimal separator
System / Interface / Output
header Output of a header for Output format:
CSV
System /Clock function Date format
Datum
Time Settings of time and date.
For details, see section 4.5.5
E
XAMPLE 2 ON NAVIGATION : S ETTING
THE DATE AND TIME , page 25
System /Service information Hardware version and software ver-
sion of the meter are displayed.
System /Reset - Resets the system settings to the
default values.
For details, see section 10.7.2
R
ESETTING THE SYSTEM SETTINGS
,
page 101