YSI MultiLab 4010-3 - Manual (Page 89)

MultiLab 4010-3 Settings
ba76143e03 08/2013 89
10.2 ORP measurement settings
Settings The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the key. After completing the set-
tings, switch to the measured value display with .
Default settings are printed in bold.
10.3 ISE measurement settings
The settings are made in the measuring menu of the ISE measurement. To
open the settings, activate the relevant measuring window in the measured
value display and press the key shortly. After completing the set-
tings, switch to the measured value display with .
The following settings are possible for ISE measurements:
3. Confirm the setting with .
4. Quit the menu with .
Menu item Possible setting Explanation
mV resolution 0.1
1 Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section
10.7.1 R
ESETTING THE MEASURE
-
MENT SETTINGS , page 98).
Menu item Possible setting Description
Calibration /
Calibration record - Displays the calibration
record of the last calibration.