Winco DGC-500 - Manual (Page 75)

DGC-500 Installation 5-1
Figure 5-1. DGC-500 Cutout Dimensions
SECTION 5 • INSTALLATION
GENERAL
DGC-500 Digital Genset Controllers are delivered in sturdy cartons to prevent shipping damage. Upon receipt
of a system, check the part number against the requisition and packing list for agreement. Inspect for damage,
and if there is evidence of such, immediately file a claim with the carrier and notify the Basler Electric Regional
Sales Office, your Sales Representative, or a Sales Representative at Basler Electric, Highland, Illinois.
If the device is not installed immediately, store it in the original shipping package in a moisture and dust-free
environment.
HARDWARE
DGC-500 controllers are packaged for mounting in any top-mount enclosure. The front panel is resistant to
moisture, salt fog, humidity, dust, dirt, and chemical contaminants. It also inhibits insect and rodent entrance.
DGC-500 controllers are mounted using the four permanently attached 10-32 studs.
MOUNTING
Case cutout dimensions are shown in Figure 5-1. Overall dimensions are shown in Figures 5-2. All dimensions
are shown in inches and millimeters (in parenthesis).