Winco DGC-500 - Manual (Page 26)

DGC-500 Functional Description 3-6
CAUTION
When the CAN interface is enabled, the DGC-500 will ignore the following
sender inputs: oil pressure, coolant temperature, and magnetic pickup.
Table 3-2. Engine Configuration Parameters Obtained from CAN Interface
t
Engine Configuration Parameter
Metric
Units
English
Units
Update
Rate
Decimal
Place SPN
Engine speed at idle point 1 rpm rpm 5 s none 188
Percent torque at idle point 1 % % 5 s none 539
Engine speed at point 2 rpm rpm 5 s none 528
Percent torque at point 2 % % 5 s none 540
Engine speed at point 3 rpm rpm 5 s none 529
Percent torque at point 3 % % 5 s none 541
Engine speed at point 4 rpm rpm 5 s none 530
Percent torque at point 4 % % 5 s none 542
Engine speed at point 5 rpm rpm 5 s none 531
Percent torque at point 5 % % 5 s none 543
Engine speed at high idle point 6 rpm rpm 5 s none 532
Gain (KP) of endspeed governor %/rpm %/rpm 5 s 100 th 545
Reference engine torque Nm ft-lb 5 s none 544
Maximum momentary engine
override speed point 7 rpm rpm 5 s none 533
Maximum momentary engine
override time limit seconds seconds 5 s 10 th 534
Requested speed control range
lower limit rpm rpm 5 s none 535
Requested speed control range
upper limit rpm rpm 5 s none 536
Requested torque control range
lower limit % % 5 s none 537
Requested torque control range
upper limit % % 5 s none 538
t Press the Select pushbutton to enter the Engine Configuration submenu. Press the Previous
pushbutton to exit the submenu.
Diagnostic Trouble Codes (DTCs)
The DGC-500 obtains the diagnostic condition of the transmitting electronic components. The DGC-500 will
receive an unsolicited message of a currently active diagnostic trouble code (DTC). Previously active DTCs
are available upon request. Active and previously active DTCs can be cleared on request. Table 3-3 lists the
diagnostic information that the DGC-500 obtains over the CAN interface.