Winco DGC-500 - Manual (Page 37)

DGC-500 Functional Description 3-17
Figure 3-8. Menu Mode Navigation
Menu Mode
Press the Select/Enter pushbutton while viewing the top-level Menu mode screen (shown in Figure 3-2), to
access the four menu branches illustrated in Figure 3-8. Press the Lower/Scroll or Raise/Scroll pushbuttons
to view the top of each menu branch. Within Menu 1, 2, 3, or 4, use the Select/Enter pushbutton to move
right, the Previous pushbutton to move left, the Raise/Scroll pushbutton to move up, and the Lower/Scroll
pushbutton to move down.
Menu 1
DGC-500 pre-alarms and alarms are viewed and configured in Menu 1. Figure 3-9 illustrates the Menu 1
screens.
Menu 2
System configuration settings are viewed and configured in Menu 2. Figure 3-10 illustrates the Menu 2
screens.
Menu 3
DGC-500 calibration, transformer ratios, and transducer failure alarms, are viewed and configured in Menu
3. Figure 3-11 illustrates the Menu 3 screens. The menu screens associated with the calibration process are
illustrated in Section 5, Installation, Calibration.
Menu 4
Engine cool-down time and cranking parameters are viewed and configured in Menu 4. Figure 3-12 illustrates
the Menu 4 screens.
Exiting Menu Mode
Pressing the Display Toggle pushbutton exits the Menu mode from any level and branch. When the Display
Toggle pushbutton is used to exit Menu mode, the user’s place within the menu tree is saved. The display
will return to the same screen the next time that Menu mode is entered. If the Display Toggle pushbutton is
pressed before a new setting is saved, the existing setting is retained.
Using the Previous pushbutton to back out of Menu mode ensures that the top-level Menu mode screen is
viewed the next time Menu mode is entered.