Winco DGC-500 - Manual (Page 4)

DGC-500 Introduction iii
PRODUCT REVISION HISTORY
The following information provides a historical summary of the changes made to the embedded firmware,
communication software (BESTCOMS), and hardware of this device. The corresponding revisions made to
this instruction manual are also summarized. This revision history is separated into four categories: Firmware
Version, BESTCOMS Version, Hardware Version, and Manual Version. All revisions are listed in reverse
chronological order.
Firmware Version Summary
2.04.XX - 10/03
C
Added Engine Start/Stop Configuration setting to accommodate Volvo
Penta EDC applications. Added CANBus Address setting and Genset kW
Rating setting.
2.03.XX - 03/03
C
Added support for SAE J1939 interface and 400 Hz operation
2.01.XX - 07/02 C Increased the maximum Sender Failure Alarm time delay setting from 10
seconds to 30 seconds.
1.00.XX - 03/02 C Initial release
BESTCOMS Version Summary
1.03.XX - 10/03
C
Added Engine Start/Stop Configuration setting to accommodate Volvo
Penta EDC applications. Added CANBus Address setting and Genset kW
Rating setting.
1.02.XX - 03/03
C
Added settings for support of SAE J1939 interface and 400 Hz operation.
1.01.XX - 07/02 C Increased the maximum setting of the Global Sender Failure Alarm Time
Delay from 10 seconds to 30 seconds.
1.00.XX - 03/02 C Initial release
Hardware Version
(Standard Order P/N) Summary
L - 10/03
C
Implemented firmware version 2.04.XX and BESTCOMS version 1.03.XX
K - 09/03
C
Added reference to instruction manual on parts list
J - 07/03
C
Implemented firmware version 2.03.XX and BESTCOMS version 1.02.XX
I
C
Not implemented
H - 06/03
C
Circuit board layout revised to improve manufacturing process
G - 04/02
C
Initial release