beautypg.com

Toa DP-SP3 User Manual

Page 73

background image

72

73

15.3.3. Output mute control

Assign the Mute ON/OFF function to the Pin.

Notes

• Output mute control is only available to the DP-SP3 unit targeted by the contact input.

• Group the output channels, then perform controls in groups.

• When “Pulse” is selected for the control method, even if the unit’s power is switched off, the output mute state

can be recalled when the power is switched on again.

• The output mute cannot be reset using the contact input for the channel of which output mute is set to ON with

the DP-SP3 PC Software.

Step 1. Set the mode to [Direct].

Step 2. Set the function to [Mute].

Step 3. Set the control to either [Make] or [Pulse].

Step 4. Select the target channel to which mute control function is assigned.