CITIZEN CT-S300 - Manual (Page 70)

— 65 —
2.2.10 Cutter Commands
GS V m ......... (1)
GS V m n ..... (2)
[Function] Cutting the paper
[Code] (1) <1D>H<56>H
(2) <1D>H<56>H
[Range] (1) m = 1, m = 49
(2) m = 66
[Outline] Performs the specified paper cutting.
[Caution] • In STANDARD MODE, this command only works when it is entered at the beginning
of a line.
• Control to make the length of cut paper less than 10 mm is not excecuted.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
≠ 0, the paper is fed by
“n
× basic calculation pitch” inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic calculation pitch (y).
A fraction resulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
m Function
0, 48 Full cut
1, 49 Partial cut (Leaving a bridge area uncut)
65 Paper feed by “cut position + {n × basic calculation pitch}” and partial cut
66 Paper feed by “cut position + {n
× basic calculation pitch}” and partial cut