Gs ! n – CITIZEN CT-S300 User Manual
Page 33
— 28 —
Bit
Function
Value
Hex. Number
Decimal Number
0
1
2
3
4
5
6
7
GS ! n
[Function]
Specifying the character size
[Code]
<1D>H<21>H
[Range]
0 n 255, where:
1 vertical magnification 8, 1 horizontal magnification 8
[Outline]
Specifies the character size (Vertical and horizontal magnification).
Table 1 Horizontal Magnification
Hex.
Decimal
Magnification
00
0
1
× (Standard)
10
16
2
× (Double width)
20
32
3
Ч
30
48
4
Ч
40
64
5
Ч
50
80
6
Ч
60
96
7
Ч
70
112
8
Ч
Vertical magnification
specification
Refer to Table 2, “Vertical
Magnification”.
Horizontal magnification
specification
Refer to Table 1, “Horizontal
Magnification”.
Table 2 Vertical Magnification
Hex.
Decimal
Magnification
00
0
1
× (Standard)
01
1
2
× (Double )
02
2
3
Ч
03
3
4
Ч
04
4
5
Ч
05
5
6
Ч
06
6
7
Ч
07
7
8
Ч
[Caution]
• This command is valid for all characters (alphanumeric, kana, and kanji) except for
HRI characters.
• This command is ignored if either the vertical magnification or horizontal
magnification is out of the defined range.
• In STANDARD MODE, the vertical direction is defined as the paper feed direction,
and the horizontal direction is defined as the direction perpendicular to the paper
feed.
• Setting memory SW 3-7 to ON allows the horizontal and vertical relations to be
interchanged when 90°-right-turnning of character is specified.
• In PAGE MODE, the vertical direction means the top-bottom direction of each
character. The horizontal direction means the side-to-side direction of each
character. If characters of different vertical magnification are contained in a line,
the baseline of each character is lined up.
• Horizontal and vertical magnification can also be specified/canceled by ESC ! but
the setting of command last processed is valid.
[Default]
n = 0
[See Also]
ESC !