CITIZEN CT-S300 - Manual (Page 65)

— 60 —
2.2.7 Paper Detecting Commands
ESC c 3 n
[Function] Selecting the Paper Sensor valid for a Paper-end signal output
[Code] <1B>H<63>H<33>H
[Range] 0 n 255
[Outline] This command selects by which Paper Sensor a Paper-end signal should be output.
Each bit for “n” has the following meaning:
[Caution] This command is valid only for the parallel interface.
[Default] n = 15
Bit Position
Value
0 1
0 Paper Near-end Disabled Enabled
1 Paper Near-end Disabled Enabled
2 Paper-end Disabled Enabled
3 Paper-end Disabled Enabled
4 Undefined — —
5 Undefined — —
6 Undefined — —
7 Undefined — —