RED DSMC POWER - Manual (Page 60)

COPYRIGHT © 2014 RED.COM, INC
RED DSMC POWER OPERATION GUIDE
955-0038, REV-F | 60
PRO I/O MODULE
When using a Pro I/O Module along with other DSMC modules, ensure that it is attached closest to the BRAIN,
behind the Module Adaptor or +1 Adaptor Module. This improves access to cables, modules, and batteries, as
well as ensuring proper power distribution.
WARNING: DO NOT use the EVF/LCD port on the +1 Adaptor Module if a Pro I/O Module is connected to the
DSMC BRAIN. The Pro I/O Module overrides the EVF/LCD and AUX power out ports when connected.
MODULE RESTRICTIONS
There are some restrictions when attaching multiple modules to the DSMC BRAIN.
DO NOT attach more than four (4) modules to the DSMC BRAIN.
DO NOT attach more than one (1) module per type.
DO NOT connect more than one (1) power or battery module to the BRAIN at a time. Backpack modules
that provide power via the 6-pin 1B LEMO power connector on the rear of the BRAIN are an exception.
Follow any other module-specific requirements when attaching modules to the BRAIN.
WARNING: It is important to read and understand the instructions for a module before you install and use it for
the first time. Failure to comply with instructions may cause irreparable damage to your camera or equipment.
WARNING: Damage caused by a failure to comply with instructions and warnings is not covered under warranty.
NOTE: For more information about compatibility and restrictions, contact your Bomb Squad representative.
MAXIMUM SUPPORTED MODULES
The DSMC supports a maximum of four (4) modules at a time, or up to one (1) of each module type. A RED-
MOTE or other device may be attached at the rear of the camera configuration.
The DSMC supports only one (1) rear battery module at a time. The DSMC BRAIN draws power from battery
modules through the SEARAY connector. Attaching more than one (1) battery module may cause damage to
the BRAIN or other components. Backpack power modules are an exception to this rule. You may attach a
backpack power module or other power source that provides input power via the 6-pin 1B LEMO DC IN port
on the BRAIN. This effectively enables support for a maximum of two (2) power sources from the rear camera
configuration.
WARNING: DO NOT attach more than four (4) modules to the rear of the camera at any time. Attaching more
than four (4) modules may cause power distribution problems or structural integrity issues such as: bowing,
connector damage, or damage to the BRAIN itself.
WARNING: DO NOT use more than one (1) DSMC battery module at a time. Using multiple battery modules may
damage the camera BRAIN and is not covered under warranty.
Module Adaptor and Pro
I/O Module