RED DSMC POWER - Manual (Page 51)

RED DSMC POWER OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0038, REV-F | 51
4-PIN TO 2-PIN ADAPTOR CABLE
The 4-Pin to 2-Pin Adaptor Cable enables you to power 2-pin based accessories from the +1 Adaptor Module
or Pro I/O Module.
2-PIN 1B LEMO-TO-FLYING LEAD CABLE
The 2-Pin 1B LEMO-to-Flying Lead Cable provides a 1B LEMO connector and flying leads for custom cable
creation. Create a custom cable for powering camera accessories using 1B 12 V ports available on DSMC
modules.
2B-TO-1B POWER ADAPTOR CABLE
The 2B-to-1B Power Adaptor Cable enables DSMC support for RED ONE power accessories that use 2B LEMO
connectors.
PRO I/O AUX POWER OUT + GPIO CABLE (6')
The Pro I/O Aux Power Out + GPIO Cable (6’) connects to the 4-pin GPIO port and/or 4-pin PWR port on the
Pro I/O Module. This cable allows you to remotely trigger the BRAIN from an external device and/or provide
unregulated +11 V to +17 V battery power to an external device.
WARNING: DO NOT attempt to make your own Pro I/O Aux Power Out + GPIO Cable.
XLR POWER CABLE
The XLR Power Cable enables you to power the DSMC BRAIN from a 4-pin XLR power source. The XLR Power
Cable is available in 30" or 10' lengths.
4-Pin to 2-Pin Adaptor
Cable
Pro I/O Aux Power Out
+ GPIO Cable (6')
XLR Power Cable