RED DSMC POWER - Manual (Page 23)

RED DSMC POWER OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0038, REV-F | 23
DSMC POWER MODULE OPERATIONS
This section describes the attachment and removal of DSMC modules. These instructions are applicable to all
DSMC modules, except adaptor modules. The Pro Battery Module (Quad) is shown.
WARNING: DSMC modules attach to an adaptor module. DSMC modules DO NOT attach directly to the BRAIN.
WARNING: Before installing or removing modules, you MUST turn off the BRAIN.
NOTE: The REDVOLT XL Module is an exception to the adaptor module requirement. For more information, go
to “Install the REDVOLT XL Module” on page 31 .
ATTACH A DSMC POWER MODULE
REQUIRED TOOL: T20 Torx driver
1. Turn off the BRAIN.
2. Insert the lip at the top of the module into the recess at the top of the adaptor module.
3. Rotate the module down flush with the rear of the adaptor module.
4. Apply pressure and use a T20 Torx driver to rotate the lock on the adaptor module clockwise to the Lock
position.
Insert Module Lip
Press Module Flush