Charge with the redvolt xl module, Red dsmc power operation guide – RED DSMC POWER User Manual

Page 30

RED DSMC POWER OPERATION GUIDE

955-0038, REV-F

CHARGE WITH THE REDVOLT XL MODULE

The REDVOLT XL Module charges one (1) REDVOLT XL battery when an AC Power Adaptor (DSMC) is con-

nected to the 6-pin 1B LEMO CHARGE IN connector. The REDVOLT XL Module can fully charge a discharged

REDVOLT XL battery in approximately four (4) hours.
The REDVOLT XL Module can charge a REDVOLT XL battery while attached to the camera, but only when the

BRAIN is off. When the BRAIN is on, power is drawn from the battery rather than the attached power supply,

resulting in a net loss of power. Connect a power source to the 6-pin 1B LEMO CHARGE IN port to provide

power to the AUX POWER OUT port for additional camera accessories.
To charge a REDVOLT XL battery with the REDVOLT XL Module, follow the instructions below:
1. Attach the protective baseplate to the REDVOLT XL Module.
2. Connect the 6-pin 1B LEMO connector from an AC Power Adaptor (DSMC) to the CHARGE IN port.
3. Insert a REDVOLT XL battery into the REDVOLT XL Module.
WARNING: DO NOT use the REDVOLT XL Module as a desktop charger without the protective baseplate to cover

the rear connectors. This may cause irreparable damage to the rear connectors on the module and is not cov-

ered under warranty.

REDVOLT XL Module Front

(left), and Rear (right)