Breaker module filter – PRG S400 User Manual 3.1 User Manual

Page 60

PRG SERIES 400

POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL

Breaker Module Filter

Parts:

40.7154.0001.0

FILTER, FAN

Tools:

Screwdriver

WARNING:

Remove power from rack before performing any maintenance procedures.

To clean a Breaker Module air filter:

Step

1. Disconnect power to rack.

Step

2. If required, remove Breaker Module from rack. Refer to

Step

3. Using screwdriver, remove filter as shown.

Step

4. Clean filter with soap and water. Dry thoroughly.

Step

5. Re-install filter.

Figure 4-3: Removing Breaker Module Air Filter

Note: The Breaker Module fan is triggered thermostatically and will only turn on if the ambient temperature inside the
chassis is too high.

Filter

15A 208V MODEL SHOWN

Rack Components May Vary