PRG S400 User Manual 3.1 - Manual (Page 17)

PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL 11
Figure 1-7: Features By Component (Part 4)
• Accepts both Virtuoso and Art-Net control protocols.
• Compatible with 10Base-T or 100Base-TX standard signals.
• When used with consoles running Virtuoso SV 4.4 or greater,
the operating mode is automatically configured according to the
input signal type
• Six DMX512 serial output ports supporting one DMX512
universe each.
• Address thumbwheel for mapping a block of Art-Net universes
to the six DMX512 outputs.
• LEDs indicating DMX Tx, RDM Tx, and RDM Rx data status for all DMX ports.
• Front panel DC power status LED.
• Standard 1U 19" rack mount chassis.
Virtuoso Node
• Six Cam-Lok Series E1016 high-current connections for power input.
• Two sets of six Cam-Lok Series E1016 high-current connections for
power output.
• Double Neutral connectors to handle excessive neutral current
generated by low power factor loads.
• Seven digital LED meters to monitor power flow - three voltmeters to
measure phase voltages and four current meters to measure current
flowing in each phase and the neutral.
• Neon indicators to show when feed cable is energized.
• Adjustable control for setting inrush limit.
• Five color coded, insulated test points for metering output voltages.
• Multiple local convenience outlets.
• Solid copper rigid bus bars and two thermostatically controlled cooling
fans allow operation at 100% of Rated current.
• Suitable for use in the U.S. and Canada, or any locality with a 5-wire,
120/208V power grid.
400 Amp Disconnect
• Accepts both Virtuoso and Art-Net control protocols.
• Compatible with 10Base-T or 100Base-TX standard signals.
• Automatic detection and mode configuration according to input
signal type.
• One Ethernet (Art-Net) output port supporting up to six DMX512
universes.
• Six DMX512 serial output ports supporting one DMX512 universe
each.
• LEDs indicating Link, TX data, and RX data status for all Ethernet ports.
• LEDs indicating DMX Tx, RDM Tx, and RDM Rx data status for all DMX ports.
• Display support for configuration of Virtuoso address, configuration of Art-Net outputs in Series 400
Mode, real-time monitoring of DMX512 data on each output, display of network error information, and
display of current software version.
• Neutrik® PowerCon® connector for input AC supply.
• Front panel DC power status LED.
• Standard 1U 19" rack mount chassis.
Virtuoso Node Plus