PRG S400 User Manual 3.1 - Manual (Page 59)

PRG SERIES 400 ® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL 53
ROUTINE MAINTENANCE
Cleaning/Replacing Air Filters
Air filters are located on the bottom of the rack tower and in each Breaker Module. These filters may need to be
cleaned periodically, depending on amount of use and/or exposure to dusty environments.
Rack Filter
Parts:
40.7153.0001.0 AIR FILTER, SERIES 400 RACK
Tools:
#2 Phillips screwdriver
WARNING: Remove power from rack before performing any maintenance procedures.
To clean the rack air filter:
Step 1. Disconnect power to rack.
Step 2. Carefully tilt rack onto one side.
Step 3. Remove four screws securing filter bracket and remove bracket and filter.
Step 4. Clean filter with soap and water. Dry thoroughly.
Step 5. Re-install filter and bracket.
Figure 4-2: Removing Rack Air Filter
Bracket
Filter